NTMC-04/05 "nDROiiD"

Controller: Flyduino Mega V2.1 by Paul Bake
Software: MultiWii 1.8 by Alex
Frame: GFK/ 15mm Alu
Gyros: Nintendo WM+
Radius: 15cm
Weight: 850g
Motors: FC2822
ESC: Turnigy Plush 25A
ESC: HK SS 18-20Props: Flyduino Green/red 8"/10"
TX: Hobbyking T6A 2,4GHz V2
RX: HK TR6A V2 + QuadroPPM12
Bat: Rhino 2100mAh, Turnigy 2200mAh
Special: Buzzer, LED-Stripes, 
FPV-System, Pitch/Roll Compensation, Barometer, Commpass and Bluetooth Modul. 

My 4th nCopter is a QuadX. The target of this project was to look as good as possible.

All wires are inside of the structure and the motors have selfmade holding brackets.
The elctronics are fitted inside of a plastic bowl, so they are protected agains dust and water.

motor holder (you can order them for small money)

direction sensing

the controller board (bolts are now replaced by plastic bolts)

the power distribution from flyduino

illumination for direction sensing

The updated version of nDROiiD features Flydusense v2, plastic bolts, and ebtter wiring

Flydusense v2 with plastic bolts

RX is now in the sandwich

buzzer has a mounting hole

the whole tower from the side